| |
|
[General Information]
|
| Processor Name: | AMD Am486 DX4 Write-Back Enhanced-108
|
| Current Processor Frequency: | 107.8 MHz
|
| Current Processor Frequency [MHz]: | 108
|
| |
|
| CPU ID: | 00000494
|
| CPU Vendor: | AuthenticAMD
|
| CPU Stepping: | CPUID Enhanced, Write-Back mode
|
| |
|
| Number of CPU Cores: | 1
|
| Number of Logical CPUs: | 1
|
| |
|
[Operating Points]
|
| CPU Current: | 107.8 MHz
|
| |
|
| CPU Bus Type: | FSB
|
| |
|
[Cache and TLB]
|
| L1 Cache: | Unified: 16 KBytes
|
| |
|
[Standard Feature Flags]
|
| FPU on Chip | Present
|
| Enhanced Virtual-86 Mode | Not Present
|
| I/O Breakpoints | Not Present
|
| Page Size Extensions | Not Present
|
| Time Stamp Counter | Not Present
|
| Pentium-style Model Specific Registers | Not Present
|
| Physical Address Extension | Not Present
|
| Machine Check Exception | Not Present
|
| CMPXCHG8B Instruction | Not Present
|
| APIC On Chip / PGE (AMD) | Not Present
|
| Fast System Call | Not Present
|
| Memory Type Range Registers | Not Present
|
| Page Global Feature | Not Present
|
| Machine Check Architecture | Not Present
|
| CMOV Instruction | Not Present
|
| Page Attribute Table | Not Present
|
| 36-bit Page Size Extensions | Not Present
|
| Processor Number | Not Present
|
| CLFLUSH Instruction | Not Present
|
| Debug Trace and EMON Store | Not Present
|
| Internal ACPI Support | Not Present
|
| MMX Technology | Not Present
|
| Fast FP Save/Restore (IA MMX-2) | Not Present
|
| Streaming SIMD Extensions | Not Present
|
| Streaming SIMD Extensions 2 | Not Present
|
| Self-Snoop | Not Present
|
| Multi-Threading Capable | Not Present
|
| Automatic Clock Control | Not Present
|
| IA-64 Processor | Not Present
|
| Signal Break on FERR | Not Present
|
| Secure Memory Encryption | Not Present
|
| Secure Encrypted Virtualization | Not Present
|
| |
|
[Enhanced Features]
|
| Core Performance Boost | Not Supported
|
| |
|
[Memory Ranges]
|
| Maximum Physical Address Size: | 32-bit (4 GBytes)
|
| Maximum Virtual Address Size: | 32-bit (4 GBytes)
|
| |
|
[General Information]
|
| Drive Controller: | E-IDE
|
| Drive Channel: | Primary, Master
|
| Drive Model: | Seagate ST31220A
|
| Drive Firmware Revision: | 800658
|
| Drive Serial Number: | 00DX537597
|
| Drive Capacity: | 1,033 MBytes
|
| Drive Capacity [MB]: | 1033
|
| |
|
[Drive Geometry]
|
| Number of Cylinders: | 2099
|
| Number of Heads: | 16
|
| Sectors Per Track: | 63
|
| Bytes Per Sector: | 580
|
| Bytes Per Track: | 36540
|
| Number Of ECC Bytes: | 4
|
| Number of Sectors: | 2115792
|
| Total 32-bit LBA Sectors: | 2116296
|
| Logical Sector Size: | 512 Bytes
|
| Cache Buffer Size: | 256 KBytes
|
| Controller Type: | Dual Ported, Multiple Sector Buffer, Read Cache
|
| |
|
[Transfer Modes]
|
| Sectors Per Interrupt: | Total: 32, Active: 32
|
| Max. PIO Transfer Mode: | 4
|
| Multiword DMA Mode: | Total: 2, Active: 0
|
| Singleword DMA Mode: | Total: -, Active: -
|
| Ultra-DMA Mode: | N/A
|
| Max. Multiword DMA Transfer Rate: | 16.7 MBytes/s
|
| Max. PIO with IORDY Transfer Rate: | 10.0 MBytes/s
|
| Max. PIO w/o IORDY Transfer Rate: | 16.7 MBytes/s
|
| Transfer Width: | 16-bit
|
| Native Command Queuing: | Not Supported
|
| TRIM Command: | Not Supported
|
| |
|
[Device flags]
|
| Fixed Drive: | Present
|
| Removable Drive: | Not Present
|
| Magnetic Storage: | Present
|
| LBA Mode: | Supported
|
| DMA Mode: | Supported
|
| IORDY: | Supported
|
| IORDY Disableable: | Not Supported
|
| |
|
[Features]
|
| Write Cache: | Not Present, Inactive
|
| S.M.A.R.T. Feature: | Not Present, Inactive
|
| Security Feature: | Not Present, Inactive
|
| Removable Media Feature: | Not Present, Disabled
|
| Power Management: | Not Present, Inactive
|
| Advanced Power Management: | Not Present, Inactive
|
| Packet Interface: | Not Present, Disabled
|
| Look-Ahead Buffer: | Not Present, Inactive
|
| Host Protected Area: | Not Present, Disabled
|
| Power-Up In Standby: | Not Supported, Inactive
|
| Automatic Acoustic Management: | Not Supported, Inactive
|
| 48-bit LBA: | Not Supported, Inactive
|
| Host-Initiated Link Power Management (HIPM): | Not Supported
|
| Device-Initiated Link Power Management (DIPM): | Not Supported
|
| In-Order Data Delivery: | Not Supported
|
| Hardware Feature Control: | Not Supported
|
| Software Settings Preservation: | Not Supported
|
| NCQ Autosense: | Not Supported
|
| Link Power State Device Sleep: | Not Supported
|
| Hybrid Information Feature: | Not Supported
|
| Rebuild Assist: | Not Supported
|
| Power Disable: | Not Supported
|
| All Write Cache Non-Volatile: | Not Supported
|
| Extended Number of User Addressable Sectors: | Not Supported
|
| CFast Specification: | Not Supported
|
| NCQ Priority Information: | Not Supported
|
| Host Automatic Partial to Slumber Transitions: | Not Supported
|
| Device Automatic Partial to Slumber Transitions: | Not Supported
|
| NCQ Streaming: | Not Supported
|
| NCQ Queue Management Command: | Not Supported
|
| DevSleep to Reduced Power State: | Not Supported
|
| Out Of Band Management Interface: | Not Supported
|
| |
|
[Security]
|
| Security Feature: | Not Supported
|
| Security Status: | Disabled
|
| Security Locked: | Disabled
|
| Security Frozen: | Disabled
|
| Enhanced Security Erase: | Not Supported
|
| Sanitize Feature: | Not Supported
|
| Sanitize Device - Crypto Scramble: | Not Supported
|
| Sanitize Device - Overwrite: | Not Supported
|
| Sanitize Device - Block Erase: | Not Supported
|
| Sanitize Device - Antifreeze Lock: | Not Supported
|
| Device Encrypts All User Data: | Not Supported
|
| Trusted Computing: | Not Supported
|